?unique=6733eff)
?unique=6733eff)
5mm PIN Navigation Light, 1Wx2, SHORT
PIN5X-010x2
A world first miniaturization with high light output: the lights from the PIN 5mm series!
Using an intricate production technique, high-performance LED chips are connected directly to an electrical cooling carrier and additionally glued. This way, with a minimal chip surface of only 3x3mm, an enormous light output can be generated and operated. The package includes four different light caps, the two round 5mm caps resembling traditional LEDs but providing up to 100 times the typical brightness with an emission angle of over 120°. The cooling and mounting pin on the back is only 3mm in diameter and can be integrated very easily even in narrowest places in rudders or the thinnest tail units.
The position light with 1W in x2 technology delivers impressive performance for model aircraft despite its compact size, with a runtime of around 7-8 minutes without additional cooling.
The design features an exposed LED chip, which acts as a ceramic carrier and can be quite delicate. We reinforce this by adding adhesive to stabilize it mechanically, but it is still crucial to handle the components with care until they are securely installed in the model.
Performance: 1Wx2 reference power
Voltage: 8(12)V, 0.1A
Beam angle: 150°
Light intensity: ~30 Lumen RED
Light intensity: ~50 Lumen GREEN
Light intensity: ~90 Lumen WHITE
Dimension: D5x20mm
Weight: 1g (without cable)
1. Cap 5mm cylindrical - can be attached directly as an all-round light
2. Cap 5mm round, focussing - when attached directly, part of the light concentrate towards the front as with the 5mm LEDs
3. Cap 7mm cylindrical - can be glued to the model and used as an alternative cover
4. Cap 5mm profile-shaped - can be attached directly and used as a small position light
Equipped with 1m connection cable. Use an additional resistor for 3S operation. (RESCARD)
| Operating Voltage: 2S/8V or 3S/12V with additional resistor |
| Cable Length: 0.5m PTFE 0,14mm² |
| Dimensions: 5mm |
| Design: Round |
| Function: Navigation/Position Light |
The design of the light includes an exposed LED chip which, as a ceramic carrier, is quite sensitive. We glue this in addition to stabilize it mechanically, but it is always necessary to handle the elements very carefully until they are firmly installed in the model.
The luminaire is ready to use for operation with 2S LiPo (8V). For 3S (12V), a resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. With heatsink installed, these lights are suitable for continuous operation when provided enough airflow (during flight). If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Warning: The LED lights are extremely bright! Never look directly into an LED!