- You do not have any products in your shopping cart yet.
15mm VERTICAL Strobe , 24x2W, T-Fuse
-50%
NOTE! Expiring Chip Generation
Electricity: 24W reference power, 8(12)V, 2A
Beam angle: >160°
Light intensity: ~600 Lumen RED
Light intensity: ~1000 Lumen GREEN
Light intensity: ~1700 Lumen WHITE
Dimension cooling tube: D 15mm,48mm
Dimension light cap: round 15x10mm, cylindric 15x15mm
Attention: in case of using the round cap you may need to grind off the edges of the chip a bit.
Total mass: D15mm, 59mm length
Weight: 10g (without cable)
Beam angle: >160°
Light intensity: ~600 Lumen RED
Light intensity: ~1000 Lumen GREEN
Light intensity: ~1700 Lumen WHITE
Dimension cooling tube: D 15mm,48mm
Dimension light cap: round 15x10mm, cylindric 15x15mm
Attention: in case of using the round cap you may need to grind off the edges of the chip a bit.
Total mass: D15mm, 59mm length
Weight: 10g (without cable)
Ready to use with 1m silicon cable and series resistor for 2S, resistor for 3S enclosed
incl 2 caps (cylindrical and round)
incl 2 caps (cylindrical and round)
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
TECHNICAL INFORMATION
CONNECTION
CONNECTION
Customer reviews
Unfortunately there are no review yet. Be the first who rate this product.
You must be logged in to submit a review. Login
