- You do not have any products in your shopping cart yet.
LARGE Wing-Blade, till 2.5m
With our night NightFly blades a simple, indirect lighting of nearly all large models with up to 2.5 meters span is possible. The delicate but very robust CFK tube construction brings enormous light output with low weight without affecting the flight characteristics.
In delivery, the pipes and plates are pre-assembled and can be shortened and aligned on the model. Optimum illumination is thus achievable. Only then the arms are permanently fixed with a few drops of epoxy. An unsymmetrical mounting is also possible (short arm near the ground).
uniLIGHT Night Blades
In delivery, the pipes and plates are pre-assembled and can be shortened and aligned on the model. Optimum illumination is thus achievable. Only then the arms are permanently fixed with a few drops of epoxy. An unsymmetrical mounting is also possible (short arm near the ground).
uniLIGHT Night Blades
- Compact size with maximum performance
- Lowest impact on flight behavior
- New cable and plugless installation
- Optimized, adjustable cooling reflector
- Reduced self-glare
- 5 sizes for all standards
- especially for wings and symmetrical for the tail
- Asymmetrical design for maximum ruggedness
- Safety holder with position light available
- large systems as cable and autonomous battery version
- First, the enclosed, small contact plate is glued firmly into the edge of the wings, sides or elevator, preferably with good epoxy and optional pegs. Make sure that the writing on the contact plates is readable so that the polarity is correct. In the top view, right is always plus.
- The connection cable is guided centrally within the surface to the fuselage. All Night Blades can simply be operated in parallel on a 2S LiPo battery or on any uniLIGHT lighting control. Pay attention to the permissible current load and sufficient battery capacity, a shutdown at deep discharge could be fatal at night!
- For commissioning, the Night-Blade is simply placed on the mounting plate with the two screws and tightened, the electrical contact succeeds automatically. Make sure that the labels are always readable.
- The reflector surfaces are bent once so that the largest possible part of the light emission is directed to the model. ATTENTION: the reflector surfaces harden and can only be bent a few times. Fix the glued surface before you align the surfaces by hand or a small pliers to prevent breakage of the splice.
- After the flight, the Night Blades can be easily unscrewed and easily transported. There is no trace left of the night flight system.
Construction: GRP / mixed aluminum construction, 5 mm CFRP pipe, pre-assembled
Electric: 8V, 2A
Light intensity: ~1200 lumens WHITE
Overall dimension: 260x57mm
Weight: 44g (without cable)
Electric: 8V, 2A
Light intensity: ~1200 lumens WHITE
Overall dimension: 260x57mm
Weight: 44g (without cable)
With mounting plate for wireless connection, 1m connection cable, pre-assembled for direct operation on 2S LiPo and on any uniLIGHT light control
TECHNICAL INFORMATION
CONNECTION
CONNECTION
Customer reviews
Unfortunately there are no review yet. Be the first who rate this product.
You must be logged in to submit a review. Login