- You do not have any products in your shopping cart yet.
7mm PRO Navigation Light, 1.5Wx2, FLAT
Miniature position Light in extremely flat design!
Sufficient radiation to comply the SERA 923/2012 with 1 §§ 17 and 19 Par. 7 of the Air Traffic Order as position light.
Transparent polycarbonate cover and flat heat sink allow installation in almost any drone.
Sufficient radiation to comply the SERA 923/2012 with 1 §§ 17 and 19 Par. 7 of the Air Traffic Order as position light.
Transparent polycarbonate cover and flat heat sink allow installation in almost any drone.
Electricity: 1.5Wx2 reference power, 8(12)V, 0.13A
Beam angle: >120°
Light intensity: ~30 LUMEN RED
Light intensity: ~60 LUMEN GREEN
Light intensity: ~110 LUMEN WHITE
Dimension cap: 7.5x19x6mm
Dimension base: 7.5x29mm
Weight: 1.5g (ohne Kabel)
Beam angle: >120°
Light intensity: ~30 LUMEN RED
Light intensity: ~60 LUMEN GREEN
Light intensity: ~110 LUMEN WHITE
Dimension cap: 7.5x19x6mm
Dimension base: 7.5x29mm
Weight: 1.5g (ohne Kabel)
Ready to use with 1m connection cable and additional resistor for 3S operation
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
TECHNICAL INFORMATION
CONNECTION
CONNECTION
Customer reviews
Unfortunately there are no review yet. Be the first who rate this product.
You must be logged in to submit a review. Login
