- You do not have any products in your shopping cart yet.
Main page » Lights » PROFILED Lights » Lights 24mm series » 24mm DUAL Navigation + Strobe Light, 15Wx2
24mm DUAL Navigation + Strobe Light, 15Wx2
Powerful, combined navigation and flash light in the 24mm design. The light fits larger models from about 2.5m wingspan and contains a navigation light and a flash light in x2 technology. Both lights are controlled individually, so the lamp has three wires, a common positive pole. The drop-shaped polycarbonate cap is screwed on and can also be painted separately, is highly transparent and unbreakable. The enclosed additional heat sink can be glued to the inside or outside of the lamp.
Electricity: 10W reference power, 8(12)V, 0.9A ,5W reference power, 8(12)V, 0.4A
Beam angle: >160°
Dimension base panel: 24x59x9mm
Thickness assembly plate: 2mm
Luminous flux: 130 Lumen RED
Luminous flux: 220 Lumen GREEN
Luminous flux: 800 Lumen WHITE
Weight: 9g (without cable)
Beam angle: >160°
Dimension base panel: 24x59x9mm
Thickness assembly plate: 2mm
Luminous flux: 130 Lumen RED
Luminous flux: 220 Lumen GREEN
Luminous flux: 800 Lumen WHITE
Weight: 9g (without cable)
Ready to use with 1m connection cable and series resistor for 2S, resistors for 3S enclosed
cooling bolt included
cooling bolt included
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
TECHNICAL INFORMATION
CONNECTION
CONNECTION
Customer reviews
Unfortunately there are no review yet. Be the first who rate this product.
You must be logged in to submit a review. Login
