- You do not have any products in your shopping cart yet.
Main page » Lights » PROFILED Lights » Lights 11mm series » 11mm PRO Strobe Light, 16Wx2, SHORT, T-Fuse
11mm PRO Strobe Light, 16Wx2, SHORT, T-Fuse
Powerful flashlight in x2 Technology – extreme luminous power. The profile light of the 11mm series is slim outside and fit optically also onto smaller models. Because of the x2-Technology, the light has an enormous luminous power and thus it's an eye-catcher even for bigger models. This luminaire is exclusively suitable for flash mode or short blink operation. In order to ensure operational reliability of luminaire and model, an overtemperature protection is on the underside of the item. If the luminaire is operated for too long and thus becoming too hot, this button switches off the light. In order to increase the life span, do not use this function permanently!
Electricity: 16Wx2 reference power, 8(12)V, 1.4A
Beam angle: >160°
Light intensity: 2x200 Lumen RED
Light intensity: 2x400 Lumen WHITE
Dimension light cap: 11.5x42.5x10mm, up to 4mm lowerable without loss of beam angle
Total mass: 11.5x70x10mm
Weight: 8g (without cable)
Beam angle: >160°
Light intensity: 2x200 Lumen RED
Light intensity: 2x400 Lumen WHITE
Dimension light cap: 11.5x42.5x10mm, up to 4mm lowerable without loss of beam angle
Total mass: 11.5x70x10mm
Weight: 8g (without cable)
Ready to use with 1m silicon cable and series resistor for 2S
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
TECHNICAL INFORMATION
CONNECTION
CONNECTION
Customer reviews
Unfortunately there are no review yet. Be the first who rate this product.
You must be logged in to submit a review. Login
