- You do not have any products in your shopping cart yet.
5mm PRO Strobelight, 3Wx2
Extremely powerful and new position / navigation light of the 5mm series is very compact and optically fits even with small models and helicopters even in the smallest positions. The delivery includes 3 highly transparent and break-proof polycarbonate caps and can be used according to taste and needs.
In terms of size, this series corresponds approximately to the classic 5mm light-emitting diode, but with a multiple output and an enormously wide radiation.
The delivery also includes a heatsink.
Cap 1: 5mm profile-shaped
Cap 2: 5mm round, cylindrical
Cap 3: 5mm round hemispherical, focusing
In terms of size, this series corresponds approximately to the classic 5mm light-emitting diode, but with a multiple output and an enormously wide radiation.
The delivery also includes a heatsink.
Cap 1: 5mm profile-shaped
Cap 2: 5mm round, cylindrical
Cap 3: 5mm round hemispherical, focusing
Electricity: 3W reference power, 8(12)V, 0.26A
Beam angle: >120°
Light intensity: 65 Lumen RED
Light intensity: 150 Lumen GREEN
Light intensity: 250 Lumen WHITE
Total mass: 4x15mm (without heatsink)
Weight: 3g
Beam angle: >120°
Light intensity: 65 Lumen RED
Light intensity: 150 Lumen GREEN
Light intensity: 250 Lumen WHITE
Total mass: 4x15mm (without heatsink)
Weight: 3g
Ready to use with 1m silicon cable and series resistor for 2S, resistor for 3S enclosed
heatsink included
heatsink included
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
TECHNICAL INFORMATION
CONNECTION
CONNECTION
Customer reviews
Unfortunately there are no review yet. Be the first who rate this product.
You must be logged in to submit a review. Login