109mm RING, SHORT

The short Ultra-Power afterburner rings are based on the same emitter technology and on the specially manufactured aluminium core PCBs, but waive the cooling ducts to save size and weight. They have a lower performance in order to enable normal operation for the model. This is basically implemented by a puposely thin cable. The rings may only be operated permanently about 1 minute and therefore, the mixing to the gas channel should only happen in the upper section. Since a too high ambient temperatures should be avoided, these rings are specially suitable for EDS systems and score with the low weight.

The light output of the emitter rings is gigantic high and even in an area of >120° to all ring sides visible. Thus, it will both directly shine into the outlet and into the nozzle, which strengthens tremendously the effect of a glowing pushing rod.

Direct operation with 2S (8V) Lipo. Please ensure sufficient cooling air during operation. The high power requirement of the afterburner rings requires sufficiently dimensioned batteries and an efficient control. Please see our recommended modules.

This ring is delivered with two 1m/0.25mm silicon cables. These cables can be plugged in parallel into the control. A boost effect can be created when using 2-Channel controls in order to operate the afterburner ring in the maximum operation mode with the highest performance via both cables. For a better light distribution, you can use our nozzle attachments under the rubric accessories.

Light Spreader